Select the distribution method of the embeds.ī boxes on the right to enter the values.Įmbed is placed on a selected position point.Įmbed is placed on a center of gravity (COG) point in the part length direction. You can define the input point sequence, lift system and embed dimensions both in reference line and cross section direction. Properties and to select the lifting anchors. Use the Placement tab to control the placing of the embeds, crane cable angles and safety factor Select how the embeds are rotated around a positionĬheck the top in form face in direction to adapt theĪ custom detail from the Applications & components catalog to be used as embed.ĭefine the thickness, width, and height of Part to the main part as welded, added material,Īdd to cast unit, or add as sub-assembly. Use the other options to connect the custom Select whether the custom parts must be used for the Select a custom part from the Applications & components catalog to be used as embed. Select the type of the anchors from the Anchor typeĪnchor created by top part and bottom part In general, a detail uses the shape of the main part for positioning the embeds, and a modeling tool uses the picked points for positioning the embeds.ĭefine embed offsets in X- and/or Y-direction, from the picked position points. Select whether the embed is handled as a detail or as a modeling tool. This option aligns the embedded anchors with the top form face of the cast You can use the global directions +X,-X,+Y,-Y,+Z,-Z or the localĭirections +X,-X,+Y,-Y,+Z,-Z to define a specific face of a typical cube-shapedĪlternatively, you can use the Top in form face option. Pick multiple points to place the embeds.Īvailable if the three-point-plane option is selected from the Input points sequence list. Select a concrete part and pick three points to define the plane. Select a concrete part and pick multiple position points for the anchors. Select a concrete part and pick one position point for the anchor. You can also adjust the placement of embeds on the Select the distribution method for the embeds. Use the Input tab to control the custom parts used for the embeds, the input points for placing theĮmbeds and the component direction properties. Wall panel reinforcement / Double wall edge and opening reinforcement.Reinforcement mesh array in area (89) / Reinforcement mesh array (91).Hole reinforcement for slabs and walls (84).Beam, column, and slab reinforcement Expand.Template attributes in drawing and report templates Expand.Get familiar with Tekla Structures Expand.Installation and licensing workflow Expand.

Tekla Structures 2023 release notes Expand.

Adding hilti anchors to tekla profile catalog